24″ X 7″ Side Spray Glass Rinser Drip Tray – Brushed Stainless – With Drain (C460)
Rinse with ease with this surface mount rinser drip tray. Simply invert the glass over the sprayer disk and press down.
Has a drip tray to drain excess water. It is removable for better cleaning.
Rinse and wet glasses before every use.
Please Note: It is recommended that you use a Pressure Limiting Valve (PLV) when connecting to a mains water line.
Includes:
- 24″ x 7″ Rinser with drip tray
- Made of Stainless steel. Comes in Brushed finish
- Rinser model with a single side spray
- Includes drain assembly
Specifications
| Material | Stainless Steel 304 |
| Finish | Brushed Stainless |
| Length | 24"x7" |
| Width | 7/8" |
| Thickness | 18 gauge |
| Standard Packing | 5 |
| Drain | Threaded Brass |
| Approvals | NSF Certified (Rinser Only) |
- Dimensions & Measurements (PDF)
- Due to slight variations in manufacturing design and the varying requirements of bench materials, it is strongly recommended to have the physical Drip Tray on hand prior to cutting into bench top surfaces. We take no responsibility for installation cut out errors and provides the sizes and dimensions as a layout guide only.
- Cleaning Instructions (PDF)
- Revit Download (PDF)
Warnings / Instructions
- Important information – Prop. 65 for CA residents.
- Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
Installation Instructions
Rinser Water Inlet Installation Instructions
- Always check with local plumbing codes before installation
- For Use with Regular or cold water supply only, Hot water is not recommended to use with a rinser
- Install in-line water regulator set at 15 PSI from the public water supply, no more than 15 Psi
- Install an in-line one-way check valve on water supply this will prevent pressure drop which can cause leakage
- Install in-line shut-off for the rinser system from the water supply, this must be turned off if not in use for extended periods such as off days or night time!
- Install a shut-off for the water supply if the line is not hard plumbed into the system.
Installation for the Drip Tray:
- Measure the exact distance between the water supply inlet (attached to the sprayer) and the drain outlet centers.
- Choose a place to install and mark two points keeping the distance between them the same as measured above.
- Drill holes through the surface over the markings:
- 22.50mm drill for water connection
- 16 mm for drain
- Place the Rinser drip tray with the inlet and outlet aligned over the holes.
- Tighten the locking nut and washer from below to hold the sprayer in position. Connect a 1/2” ID hose to the hose barb and the other end to the water supply.
- Setup the drain assembly in the outlet hole with washer and hex nut. Attach another hose to the drain outlet to carry away used water.
- Open the water supply, press the rinser plate down with an inverted glass and check for any leaks on both the connections.
WhatsApp
