10" x 7" Center Spray Glass Rinser Drip Tray - Brushed Stainless - With Drain C465 kromedispense
10" x 7" Center Spray Glass Rinser Drip Tray - Brushed Stainless - With Drain C465 kromedispense
8" x 8" Center Spray Glass Rinser Drip Tray - Brushed Stainless - With Drain C464 kromedipense
Part Number : C465

10″ x 7″ Center Spray Glass Rinser Drip Tray – Brushed Stainless – With Drain

The Drain Tray has an improved design which ensure easy drainage

Sign In to View Price

10″ x 7″ Center Spray Glass Rinser Drip Tray – Brushed Stainless – With Drain (C465)

Center spray rinser drip tray for bars and cafes. Also has a drain plate. Clean glassware by pressing down the rinser disk and leave them inverted on the plate to drain off excess water.

Can use in two ways:
Wash glasses after use
Wet fresh glass before pouring and mixing drinks

All Krome rinsers are NSF certified.

Please Note: It is recommended that you use a Pressure Limiting Valve (PLV) when connecting to a mains water line.

  • 10” X 7” Rinser with drip tray
  • Made of Stainless steel material. Brushed finish
  • Center mount rinser model
  • Includes drain assembly

Specifications

MaterialStainless Steel 304
FinishBrushed Stainless
Length10"
Width7"
TypeWith Drain
Thickness18 gauge
Standard Packing9
ApprovalsNSF Certified (Rinser Only)
Dimensions & Measurements (PDF)
Due to slight variations in manufacturing design and the varying requirements of bench materials, it is strongly recommended to have the physical Drip Tray on hand prior to cutting into bench top surfaces. We take no responsibility for installation cut out errors and provides the sizes and dimensions as a layout guide only.

Warnings / Instructions

Important information – Prop. 65 for CA residents.
Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.

Replacement Parts

Item #Part NumberReplacement Part
1Replacement Plastic Rinser Disk C334.04 kromedispenseC334.04Replacement Plastic Rinser DiskSign In to View PriceAdd to Cart
2Pitcher Rinser Spray Assembly C334.13 KROMEDISPENSEC334.13Pitcher Rinser Spray Assembly-NSF CertifiedSign In to View PriceAdd to Cart
31/2" BSP Connector With 3/8" OD X 5 Feet Hose - PP Pipe Assembly C029 kromedispenseC0291/2″ BSP Connector With 3/8″ OD X 5 Feet Hose – PP Pipe AssemblySign In to View PriceAdd to Cart
43-1/2" Standard Drain Assembly C958 kromedispenseC9583-1/2″ Standard Drain AssemblySign In to View PriceAdd to Cart

Installation Instructions

Rinser Water Inlet Installation Instructions

  • Always check with local plumbing codes before Installation
  • For Use with Regular or cold water supply only, Hot water is not recommended to use with rinser
  • Install in-line water regulator set at 15 PSI from the public water supply, no more than 15 Psi
  • Install an in-line one-way check valve on water supply this will prevent pressure drop which can cause leakage
  • Install in-line shut-off for the rinser system from the water supply, this must be turned off if not in use for extended periods such as off days or night time!
  • Install a shut-off for the water supply if the line is not hard plumbed into the system.

Related Products