Part Number : C848

16″ x 7″ Glass Rinser Drip Tray – Brushed Stainless – With Drain


The Drain Tray has an improved design which ensure easy drainage

Sign In to View Price

16″ x 7″ Glass Rinser Drip Tray – Brushed Stainless – With Drain (C848)

Center spray rinser drip tray for bars and cafes. Also has a drain plate. Clean glassware by pressing down the rinser disk and leave them inverted on the plate to drain off excess water. Has a special stainless steel rinser plate instead of the usual disk.

Can use in two ways:
Wash glasses after use
Wet fresh glass before pouring and mixing drinks

All Krome rinsers are NSF certified.

Please Note: It is recommended that you use a Pressure Limiting Valve (PLV) when connecting to a mains water line.

  • 16” X 7” Rinser with drip tray
  • Made of Stainless steel material. Brushed finish
  • Center rinser spray model
  • Includes drain assembly

Specifications

MaterialStainless Steel
FinishBrushed Stainless
TypeWith Drain
Length16"
Width7"
Thickness19 gauge
Standard Packing4
ApprovalsNSF Certified (Rinser Only)
Dimensions & Measurements (PDF)
Pdf
Cut Sheet (PDF)
C848 cut out

Warnings / Instructions

Important information – Prop. 65 for CA residents.
Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.

Replacement Parts

Replacement Part Drawing
Item #Part NumberReplacement Part
1Glass Rinser Jali C360.03 kromedispenseC360.03Krome Glass Rinser Replacement Disk onlySign In to View PriceAdd to Cart
2Glass Rinser Cap C306.06x1 kromedispenseC360.06x1Glass Rinser CapSign In to View PriceAdd to Cart
3Glass Rinser Cap Holder C360.07 kromedispenseC360.07Glass Rinser Cap HolderSign In to View PriceAdd to Cart
4Brass Fitting 1/4” NPT x 5/16” ID Hose C525 KromedispenseC525Brass Fitting 1/4” NPT x 5/16” ID HoseSign In to View PriceAdd to Cart
5Glass Rinser Subassembly for Drip Tray - Replacement C4028.50 kromedispenseC4028.50Replacement Glass Rinser for Drip Tray – Replacement- NSF CertifiedSign In to View PriceAdd to Cart
61/2" BSP Connector With 3/8" OD X 5 Feet Hose - PP Pipe Assembly C029 kromedispenseC0291/2″ BSP Connector With 3/8″ OD X 5 Feet Hose – PP Pipe AssemblySign In to View PriceAdd to Cart
73-1/2" Standard Drain Assembly C958 kromedispenseC9583-1/2″ Standard Drain AssemblySign In to View PriceAdd to Cart

Installation Instructions

Rinser Water Inlet Installation Instructions

  • Always check with local plumbing codes before Installation
  • For Use with Regular or cold water supply only, Hot water is not recommended to use with rinser
  • Install in-line water regulator set at 15 PSI from the public water supply, no more than 15 Psi
  • Install an in-line one-way check valve on water supply this will prevent pressure drop which can cause leakage
  • Install in-line shut-off for the rinser system from the water supply, this must be turned off if not in use for extended periods such as off days or night time!
  • Install a shut-off for the water supply if the line is not hard plumbed into the system.